Cert-Ex™ Lab Simulator for Network+ : Practice Lab Exercises

VTP configuration to establish client/server connection

Description : This lab exercise helps to understand the configuration process of VLAN Trunking Protocol (VTP) to establish a server and client connection , assigning VLANs to multiple ports, creating a trunk line between switches to carry VLANs.

lab image

Instructions:

1. Assign IP address 192.168.100.1 255.255.255.0 to SW1 on its interface and IP address of 192.168.100.2 255.255.255.0 to SW2 on its vlan interface

2. Add vlan 30 and 40 to SW1 and assign ports 2 through 5 to vlan 30 and assign ports 6 through 10 to vlan 40

3. To verify the configuration, issue show vlan command on SW1

4. Configure SW1 as a VTP Server and SW2 as a VTP Client and change the VTP domain to certexams and assign a VTP password of ccna

5. To create the trunk link that will transport the VLAN configurations from SW1 to SW2, enable trunking on the port that links between the two switches

6. After this configuration, you should be able to view the VLANs from SW1 on SW2.
Use show vlan command to verify the VLAN configurations, and show vtp status command to display VTP specific information

Note: Please refer to the CertExams.com Lab Simulator For Network+ software for complete lab with commands. 


CertExams Blog!  Certexams.com Facebook Page Certexams.com Twitter Page Certexams on YouTube 

Cert-Ex™ Exam Simulators, Cert-Ex™ Network Simulator, Cert-Ex™ Cheatsheets are written independently by CertExams.com and not affiliated or authorized by respective certification providers. Cert-Ex™ is a trade mark of CertExams.com or entity representing Certexams.com.Network+™ is a trademark of CompTIA® organization.