Cert-Ex™ Lab Simulator for Network+ : Practice Lab Exercises

Implementing static routes

Description : This lab demonstrates configuring and implementing static routes in a network.

lab image

Instructions:

1.Configure R1 Ethernet interface with IP Address 192.168.201.1/24 and serial interface with IP Address 192.168.1.1/24 and enable the interfaces

2. Configure R2 Ethernet interface with IP Address 192.168.200.1/24 and serial interface with IP Address 192.168.1.2/24 and enable the interfaces

3. Configure workstations WS1 and WS2 with the IP addresses and default-gateways as shown in the figure

4. Ping from R1 to R2, R1 to WS1 and R2 to WS2 and see that they are successful

5. Ping from WS1 to WS2 and see that it fails

6. Now set up a static route on R1 and R2 using ip route command and by specifying the appropriate destination address and next hop address

7. Now ping from WS1 to WS2 and see that it is success and also verify that any device can ping any other device

Note: Please refer to the CertExams.com Lab Simulator For Network+ software for complete lab with commands.


CertExams Blog!  Certexams.com Facebook Page Certexams.com Twitter Page Certexams on YouTube 

Cert-Ex™ Exam Simulators, Cert-Ex™ Network Simulator, Cert-Ex™ Cheatsheets are written independently by CertExams.com and not affiliated or authorized by respective certification providers. Cert-Ex™ is a trade mark of CertExams.com or entity representing Certexams.com.Network+™ is a trademark of CompTIA® organization.