Network+™ Lab Simulator Exercises

Basic switch interface configuration

Description: You configure a few switch ports for duplex. Choose 2950 switch from the n/w diagram and exit. The following commands are used for configuring the switch ports.


1. Set the inter-switch communication to full-duplex on Switch S1, port fa 0/26

2. Set the port speed to 100 mbps, and inter-switch communication to full-duplex on Switch S2 ports fa 0/1, fa 0/2, and fa 0/3.

3. Eixit to privileged mode.

4. Save the configuration to NVRAM.

2950#configure terminal
2950(config)#interface fa 0/1
2950(config-if)#duplex full
2950(config)#interface fa 0/3
2950(config-if)#duplex full
2950(config-if)#speed 100
2950#copy running-config startup-config

CertExams Blog! Facebook Page Twitter Page Certexams on YouTube