Cert-Ex™ Lab Simulator for Network+ : Practice Lab Exercises

2950 Trunking Configuration

Description: This exercise concentrates on establishing a trunk-line between the switches. The command used to configure trunking is switchport mode trunk.

lab image

Instructions:

1. Connect to SW1 and configure fast ethernet interface fa 0/11 on the switch

2 Configure trunking on the switch by issuing command switchport mode trunk

3. Connect to SW2 and configure fast ethernet interface fa 0/11 on the switch

4. Configure trunk line on the switch by issuing switchport mode trunk command

5. Configure WS1 with IP Address 192.168.100.1/24 and WS2 with IP Address 192.168.100.2/24


Note: Please refer to the CertExams.com Lab Simulator For Network+ software for complete lab with commands.


CertExams Blog!  Certexams.com Facebook Page Certexams.com Twitter Page Certexams on YouTube 

Cert-Ex™ Exam Simulators, Cert-Ex™ Network Simulator, Cert-Ex™ Cheatsheets are written independently by CertExams.com and not affiliated or authorized by respective certification providers. Cert-Ex™ is a trade mark of CertExams.com or entity representing Certexams.com.Network+™ is a trademark of CompTIA® organization.